Group: Hardware/Computers/Single Board Computers/TBS2910 Matrix ARM mini PC
(→Boot settings) |
|||
| Line 55: | Line 55: | ||
</pre> | </pre> | ||
| − | The value of | + | The value of BT_FUSE_SEL is available SRC_SBMR2[4] which is 0 here. |
Revision as of 21:24, 11 January 2020
Introduction
The TBS2910 Matrix ARM mini PC is an I.MX6 Quad SBC.
Upstream support
u-boot: tbs2910_defconfig
Linux: imx6q-tbs2910.dts
Boot settings
The board I have has the following markings on the PCB: TBS-2910V23
The schematics don't seem to fully match as I've a switch component with 4 switches inside whereas the schematics have 8.
Hence my need to document the boot settings.
SRC_SBMR2 is at 0x020D801C according to the IMX6DQRM.pdf reference manual.
[root@parabola ~]# devmem2 0x020D801C w /dev/mem opened. Memory mapped at address 0xb6fb9000. Value at address 0x20D801C (0xb6fb901c): 0x2000001
BMOD[1:0] are the bits 24 and 25 of that register, which are 10.
BMOD is a register field that correspond to the BOOT_MODE settings, which are explained in the table below or the table in the "8.2.1 Boot mode pin settings" chapter of the reference manual.
| BOOT_MODE[1:0] | Boot Type |
|---|---|
| 00 | Boot From Fuses |
| 01 | Serial Downloader |
| 10 | Internal Boot |
| 11 | Reserved |
So we are in "Internal Boot" mode.
[root@parabola ~]# devmem2 0x020D801C w /dev/mem opened. Memory mapped at address 0xb6fb9000. Value at address 0x20D801C (0xb6fb901c): 0x2000001
The value of BT_FUSE_SEL is available SRC_SBMR2[4] which is 0 here.
