Group: Software/FSDG distributions/Filesystems
From LibrePlanet
(→Filesystems: Pureos: also unify missed rootfs) |
(→Filesystems: Add distros footer as the table became big) |
||
Line 398: | Line 398: | ||
| <!-- Trisquel 10 (nabia) --> | | <!-- Trisquel 10 (nabia) --> | ||
| <!-- Ututo S --> | | <!-- Ututo S --> | ||
+ | |- | ||
+ | ! rowspan=2 | | ||
+ | ! Dragora | ||
+ | ! Dynebolics | ||
+ | ! Guix | ||
+ | ! Hyperbola | ||
+ | ! LibreCMC | ||
+ | ! Parabola | ||
+ | ! ProteanOS | ||
+ | ! PureOS 10 (byzantium) | ||
+ | ! Replicant 6.0 | ||
+ | ! Trisquel 10 (nabia) | ||
+ | ! Ututo S | ||
+ | |- | ||
+ | ! colspan=11 | Distributions | ||
|} | |} | ||
Revision as of 18:02, 3 March 2023
Introduction
This article is about filesystems support and might be extended to take into account block device technologies too like LVM,RAID, etc.
Filesystems
Distributions | |||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Dragora | Dynebolics | Guix | Hyperbola | LibreCMC | Parabola | ProteanOS | PureOS 10 (byzantium) | Replicant 6.0 | Trisquel 10 (nabia) | Ututo S | |||||||||||||||||||||||||||||||||||||
btrfs |
|
|
|
||||||||||||||||||||||||||||||||||||||||||||
exfat |
|
||||||||||||||||||||||||||||||||||||||||||||||
ext4 |
|
|
|
|
|
|
|||||||||||||||||||||||||||||||||||||||||
f2fs |
|
|
|
|
|||||||||||||||||||||||||||||||||||||||||||
fat |
|
|
|
|
|||||||||||||||||||||||||||||||||||||||||||
hfs | No[5] | No[6] | No[7] | No[8] | |||||||||||||||||||||||||||||||||||||||||||
hfs+ | No[9] | No[10] | No[11] | No[12] | |||||||||||||||||||||||||||||||||||||||||||
minix |
|
||||||||||||||||||||||||||||||||||||||||||||||
ntfs |
|
||||||||||||||||||||||||||||||||||||||||||||||
Dragora | Dynebolics | Guix | Hyperbola | LibreCMC | Parabola | ProteanOS | PureOS 10 (byzantium) | Replicant 6.0 | Trisquel 10 (nabia) | Ututo S | |||||||||||||||||||||||||||||||||||||
Distributions |
Block device layer
Distributions | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
Dragora | Dynebolics | Guix | Hyperbola | LibreCMC | Parabola | ProteanOS | PureOS 10 (byzantium) | Replicant 6.0 | Trisquel 10 (nabia) | Ututo S | |
LVM2 |
References
- ↑ 1.01.11.21.3 This tells if that filesystem can be used in a system.scm system definition.
- ↑ 2.02.12.22.32.42.52.62.72.8 Since users simply run commands manually during the manual installation, they can easily use the (packaged) tools to create new filesystems and add them to /etc/fstab for automatic mounting.
- ↑ The installation fails with an error.
- ↑ The installation fails with an error.
- ↑ There is no hfsutils package.
- ↑ There is no hfsutils package.
- ↑ There is no hfsutils package.
- ↑ There is no hfsutils repository in the manifest.
- ↑ There is no hfsprogs package.
- ↑ There is no hfsprogs package.
- ↑ There is no hfsprogs package.
- ↑ There is no hfsprogs repository in the manifest.
- ↑ The installation fails with an error.
- ↑ Once installed, the rootfs is mounted with FUSE and ntfs-3g.
- ↑ The installation succeeds, but then sudo and policykit are broken due to wrong permissions. So users can't install any software. It's also a very bad idea to use NTFS since there is at the time of writing no way to safely repair corrupted NTFS filesystems with free software: The only tools we have are in ntfs-3g and they are way too experimental and dangerous so they are probably not shipped by any distribution.